View source for LQ043 Adapt

This adaptor board allows you to connect a Sharp's LQ043 LCD to your DevLight or DevFull.<br>
The description, the datasheet and the schematics of can be found here [http://www.armadeus.com/english/products-peripherals-lq043_adapt.html]

= Connection to the APF9328 Devlight V1 =
On the Devlight V1, the LCD port is not prerouted. This means that you have to solder several wire between the vias corresponding to the LCD signals and a free place on the board where you can add a 2x15pins header.

Take a look at the Devlight datasheet. You will find a table representing the bottom side of the board.
On the board (bottom), you will see a silkscreen indicating the names of each vias.

In the LQ043_Adapt datasheet, you will find the pin description of the 2x15 pins connector. 

Connect (1 to 1) the signals of the LQ043_adapt to the ones of the Devlight.
  
* [http://www.armadeus.com/_downloads/apf9328DevLight/documentation/ DevlightV1 datasheet]

= Connection to the APF9328 Devlight V2 =
A simple flat cable (PC like) can be used to connect the LQ043_Adapt to the DevLight V2. 

Align the pins 1 (square via) on both boards together.
[[Image:LQ043_Adapt_to_DevLightV2.jpg]]

* [http://www.armadeus.com/_downloads/apf9328DevLight/documentation/ DevlightV2 datasheet]



[[Category:ExtensionBoards]]
[[Category:LCD]]