Difference between revisions of "Opos6ul sp fpga simple howto"
From ArmadeusWiki
(→Software tools) |
(→Architecture) |
||
| Line 8: | Line 8: | ||
= Architecture = | = Architecture = | ||
| − | [[File:opos6ul_sp_fpga_tuto_01.png]] | + | [[File:opos6ul_sp_fpga_tuto_01.png|center]] |
| + | |||
| + | In this tutorial, a simple FPGA design will be done. The objective is to instanciate a block of RAM in the FPGA and be able to read and write data in it from U-Boot then Linux. | ||
= Software tools = | = Software tools = | ||
Revision as of 10:32, 22 July 2020
Page under construction...
Informations on this page are not guaranteed !!
Introduction
This page is a step-by-step tutorial to explain how to develop with FPGA (spartan6) on OPOS6UL_SP Armadeus board.
Architecture
In this tutorial, a simple FPGA design will be done. The objective is to instanciate a block of RAM in the FPGA and be able to read and write data in it from U-Boot then Linux.
Software tools
A recent Armadeus BSP is required.
$ git clone git://git.code.sf.net/p/armadeus/code op6sp $ cd op6sp $ make $ make opos6ulsp_defconfig $ make
