Difference between revisions of "MMC/SD"
From ArmadeusWiki
(→Supported Cards) |
m (→uSD/Transflash:) |
||
Line 48: | Line 48: | ||
===uSD/Transflash:=== | ===uSD/Transflash:=== | ||
− | * Sandisk 512MB -> | + | * Sandisk 512MB -> recognized but data tranfer is failing when accessing partition table (bad CRC) |
<br> | <br> |
Revision as of 12:32, 20 February 2007
How-To connect an MMC/SD adapter to the APF9328 (through DevLight board)
For instructions on how to use MMC/SD on Linux, see MultiMediaCard page.
Contents
Adapter board
We have designed a small adapter board with an MMC/SD connector on it. You need to connect the signals listed in the table below to the APF9328DevLight board one. The WP and CD_SW signals are optional and must be connected to free IOs if used.
Top view:
Adapter Pin | Desc | Adapter Pin | Desc |
1 | +3.3V | 2 | SD_DAT2 |
3 | SD_CMD | 4 | SD_DAT3 |
5 | SD_CLK | 6 | SD_DAT0 |
7 | WP | 8 | SD_DAT1 |
9 | CD_SW | 10 | GND |
Remarks:
- Pin 1 (rectangular pad)
- WP: write protect
- CD_SW: Card Detect switch
Supported Cards
Here is a list of the current cards which were tested:
MMC
- Hama 256MB -> OK
MMC+
- Kingston 256MB -> OK
SD:
- Kingston 512MB -> need more perf tests but seems to work
- Kingston 256MB -> OK
- Dane-Elec 2GB -> doesn't work : Card recognized but partition table not found.
- Transcend 2GB (x150) -> OK
miniSD:
- Dane-Elec 1GB -> doesn't work : Card recognized but partition table not found.
uSD/Transflash:
- Sandisk 512MB -> recognized but data tranfer is failing when accessing partition table (bad CRC)