Keypad
Contents
How to connect a keypad to your Armadeus board
Introduction
Your armadeus board allows you to connect a keypad as input device. The default keypad software driver configuration supports 16 keys connected to the CSI bus. The current development state of the driver is unfinished and not fully generic but you can easily extend the driver to support up to 36 keys keypad using the whole CSI bus.
Hardware
By default your armadeus board supports a direct connection with a 4x4 matrix using the CSI lines: CSI_MCLK,CSI_D0..CSI_D6 The driver uses the internal gpios pull-up therefore your board does not need any additional external resistor. Connect the 4 (rows) lines of the keypad to CSI_MCLK, CSI_D0, CSI_D1, CSI_D2. Connect the 4 (columns) lines of the keypad to CSI_D3, CSI_D4, CSI_D5 CSI_D6. {add a big picture of the keypad link with APF_DEV_LIGHT} {add a big picture of the keypad link with APF_DEV_FULL}
Software driver
link to software driver
Links
external links (for exemple: locomo driver model)
