APF27 FPGA-IMX interface description

This article describe the interface between IMX and Spartan3A on APF27. Documentation of i.MX interface can be found in reference manual chapter 17 «Wireless External Interface Module (WEIM)».

Hardware

Electronic schematic of apf27 fpga interface can be found on this document page 11. Simplified schema is describe bellow on figure 1.

figure 1 - FPGA-i.MXL wiring

Signals used in design are :

• CLKO : Clock generated by i.MX used as general clock by the fpga.
• DATA[16] : 16 bits data bus.
• ADDR[13] : 12 bits data bus, least significant bit (ADDR[0]) is not used because only word access are done.
• CS4N_DTACK: Chip Select 4 or Data Transmit ACKnowledge.
• CS5,CS1 : Chip Select 5 and 1.
• EB0N and EB1N: For Enable Byte, write signal for lower byte and upper byte on data bus.
• OEN : For Output Enable bit, read signal.
• DMA_GRANT# and DMA_REQ# : Signals to use DMA on i.MX.

Each chip select has its own configuration that can be use for slave that have differents timings.

CLKO is configured at 133MHz to be synchronous with WEIM bus that is internally clocked at 133MHz too.

Chip Select Timings configuration

Present configuration use CS5 for accessing FPGA. 32 bits register CS5 is used to configure all timing for this chip select. It's default configuration is :

• CS5U (Upper 16bits,see page 521 of reference manual ) : mw D8002050 00000600

This will add 6 waits state on access to read value correctly (WSC : Wait State Control).

• CS5L (Lower 16bits,see page 525 of reference manual) : mw D8002054 00000D01

Enable chip select (CSEN), Enable EB[] (EBC) and select data port size to 16bits (DSZ : Data port SiZe).

• CS5A (additionnal register, page 528) : mw D8002058 0

Software

All registers configuration for external memory are done in u-boot. Configuration file can be found in buildroot/project_build_armv5te/<project_name>/u-boot-1.3.4/include/configs/apf27.h And is saved in armadeus tree at buildroot/target/device/armadeus/apf27/apf27.h