Difference between revisions of "APF/OPOS as Wi-Fi Access Point"
From ArmadeusWiki
(→Installation) |
(→Configuration) |
||
| Line 16: | Line 16: | ||
==Configuration== | ==Configuration== | ||
| + | * Bring up your Wi-Fi interface and give it an address (here 192.168.2.1): | ||
| + | <pre class="apf"> | ||
| + | # ifconfig wlan0 up 192.168.2.1 netmask 255.255.255.0 | ||
| + | </pre> | ||
* Create ''/etc/hostapd/'' directory and put it ''hostapd.conf'' configuration file: | * Create ''/etc/hostapd/'' directory and put it ''hostapd.conf'' configuration file: | ||
<pre class="apf"> | <pre class="apf"> | ||
| − | + | # mkdir -p /etc/hostapd/ | |
| − | + | # vi /etc/hostapd/hostapd.conf | |
interface=wlan0 | interface=wlan0 | ||
| Line 32: | Line 36: | ||
* here we used fixed channel (6) (as some drivers can't allow hostapd to find less occupied channel through scanning) | * here we used fixed channel (6) (as some drivers can't allow hostapd to find less occupied channel through scanning) | ||
* security is WPA2-PSK. To have "Open" Access Point uncomment ''#auth_algs=1'' and comment 3 wpa lines | * security is WPA2-PSK. To have "Open" Access Point uncomment ''#auth_algs=1'' and comment 3 wpa lines | ||
| + | |||
| + | * Launch hostapd: | ||
| + | <pre class="apf"> | ||
| + | # hostapd -B /etc/hostapd/hostapd.conf | ||
| + | </pre> | ||
| + | * If the devices connecting to your Access Point require dynamic IP adress allocation, you will need to install and launch a DHCP server on your APF too. | ||
Revision as of 22:35, 16 September 2015
Page under construction...
Informations on this page are not guaranteed !!
Installation
- You will need hostapd (installed by default on APF6):
$ make menuconfig
Target packages --->
Networking applications --->
[*] hostapd
[ ] Enable EAP
[ ] Enable WPS
Configuration
- Bring up your Wi-Fi interface and give it an address (here 192.168.2.1):
# ifconfig wlan0 up 192.168.2.1 netmask 255.255.255.0
- Create /etc/hostapd/ directory and put it hostapd.conf configuration file:
# mkdir -p /etc/hostapd/ # vi /etc/hostapd/hostapd.conf interface=wlan0 ssid=APF6 hw_mode=g channel=6 #auth_algs=1 wpa=2 wpa_passphrase=YOUHOULESBILOUS wpa_key_mgmt=WPA-PSK WPA-PSK-SHA256
- here we used fixed channel (6) (as some drivers can't allow hostapd to find less occupied channel through scanning)
- security is WPA2-PSK. To have "Open" Access Point uncomment #auth_algs=1 and comment 3 wpa lines
- Launch hostapd:
# hostapd -B /etc/hostapd/hostapd.conf
- If the devices connecting to your Access Point require dynamic IP adress allocation, you will need to install and launch a DHCP server on your APF too.
