Difference between revisions of "BootStrap"
Revision as of 12:19, 19 September 2006
Instructions to use the Armadeus Bootstrap utility
Bootstrap utility is a Perl piece of code that allows you to interactivly communicate with the iMX processor while in bootstrap mode. To enter bootstrap mode, you have to put bootstrap jumper and restart your Armadeus board.
Go inside the boostrap folder and launch sh runBootstrap.sh if you're on Linux or runBootstrap.bat if you're on Window$
Boostrap tool will then try to synchronize with iMX:
Initializing serial port to 19200 bps Re-synchronizing... Please reset your board in bootstrap mode ! Please reset your board in bootstrap mode ! Please reset your board in bootstrap mode ! Please reset your board in bootstrap mode !
When you see that message reset your board.
if nothing happens, verify your bootstrp jumper is put and try to reset your board. At last check you serial port device is the right one.
Fisrt thing to do when entering bootstrap is initializing your SDRAM controller if you want to use it:
Then you can for example flash u-boot with:
loadFLASHbin u-boot.bin 10000000
To have a list of all the functionnalities, try: