Difference between revisions of "Chimei LW700"
From ArmadeusWiki
(→(1) Flat cable) |
|||
| Line 19: | Line 19: | ||
==(1) Flat cable== | ==(1) Flat cable== | ||
| − | A simple flat cable (PC like) can be used to connect the | + | A simple flat cable (PC like) can be used to connect the LW700_Adapt to the [[APF27Dev]]. If you do not have one, a ready to use cable [http://www.store.armadeus.com/index.php?language=en can be found here.] <br> |
Align the pins 1 (square via) on both boards together. | Align the pins 1 (square via) on both boards together. | ||
'''Do not use long cables.''' | '''Do not use long cables.''' | ||
Revision as of 16:31, 17 December 2009
Page under construction...
Informations on this page are not guaranteed !!
This adaptor board allows you to connect a CHIMEY LW700AT LCD to your DevFull.
The description, the datasheet and the schematics of this adaptor board can be found here.
The following table summarizes the possibilities to connect the LQW700AT and the Touchscreen to your development board:
| APF27Dev | |
|---|---|
| TFT usage | flat cable (1) connected between J10 of the APF27Dev and X5 of the LCD_Adapt |
| Touchscreen usage | 4 wires cable (2) connected between X2 of the LCD_Adapt and J14 of the APF27Dev |
Contents
(1) Flat cable
A simple flat cable (PC like) can be used to connect the LW700_Adapt to the APF27Dev. If you do not have one, a ready to use cable can be found here.
Align the pins 1 (square via) on both boards together.
Do not use long cables.
(2) 4 wires cable
It is a simple one to one 4 wire cables (2.54mm single row headers on both boards: LQ043_adapt and Devfull)
