Difference between revisions of "Communicate"
From ArmadeusWiki
m |
m |
||
| Line 1: | Line 1: | ||
| − | How-To connect | + | How-To connect your Armadeus board to your development Host. |
==Forewords== | ==Forewords== | ||
| Line 6: | Line 6: | ||
==Connection Setup== | ==Connection Setup== | ||
| − | The RS232 tool (serial link) and TFTP tool (ethernet link) have to be configured according to your Host operating system | + | The RS232 tool (serial link) and TFTP tool (ethernet link) have to be configured according to your Host operating system: |
===Linux=== | ===Linux=== | ||
| − | [[ | + | [[Connection with U-Boot on Linux]] |
===Window$=== | ===Window$=== | ||
Revision as of 11:07, 3 October 2006
How-To connect your Armadeus board to your development Host.
Forewords
The default connection uses a simple RS232 link (crossover cable).
Note: if your Armadeus board is equipped with an ethernet controller, this link can be used to speed up the linux and rootfs downloads.
Connection Setup
The RS232 tool (serial link) and TFTP tool (ethernet link) have to be configured according to your Host operating system:
Linux
Connection with U-Boot on Linux
Window$
uBoot communication
- RS232 cable connected
- Bootstrap jumper removed
- Start the RS232 tool
- Reset the board
- uboot must start
screenshot
