Difference between revisions of "USB to Ethernet adapter"

From ArmadeusWiki
Jump to: navigation, search
(Additional tools)
Line 32: Line 32:
<pre class="config">
<pre class="config">
Package Selection for the target --->
Target packages --->
     [*] Networking  --->
     Networking applications --->
             [*] ethtool
             [*] ethtool
            [*]  enable pretty printing

Revision as of 08:40, 30 April 2020

How-to use USB to Ethernet adapters


Tested hardware


The SMSC LAN9500 is a Hi-Speed USB 2.0 to 10/100 Ethernet Controller. The datasheet can be found here: http://www.smsc.com/media/Downloads_Public/Data_Sheets/9500.pdf. An external EEPROM is used to store the LAN9500 configuration.

Kernel configuration

$ make linux-menuconfig
 Device Drivers  --->
    [*] Network device support  --->
        USB Network Adapters  --->
            <M> Multi-purpose USB Networking Framework
            <M> CDC Ethernet support
            <M> SMSC LAN95XX based USB 2.0 10/100 ethernet devices

Additional tools

In order to read/write the configuration eeprom of the LAN9500, Ethtool has to be used.

$ make menuconfig
Target packages  --->
    Networking applications  --->
            [*] ethtool
            [*]   enable pretty printing


First mount the module:

# modprobe smsc95xx

then start the new ethernet port

# ifconfig usb0 up

If the message "No EEPROM present" is displayed, this indicates that no configuration file has been detected in the EEPROM. The LAN9500 will start in a default mode and the MAC address will be randomly generated by Linux. The EEPROM can be read/write by using ethtool once the module loaded

 ethtool -e usb0   # (eeprom read)
 ethtool -E usb0 magic 0x9500 offset xxx value xxx  # (eeprom write value at offset)

Additional informations concerning the EEPROM containt can be found on the SMSC web site.