Difference between revisions of "USB to Ethernet adapter"
(New page: How-to use USB to Ethernet adapters ==Prerequesities== ==Tested hardware == === SMSC LAN9500 === The SMSC LAN9500 is a Hi-Speed USB 2.0 to 10/100 Ethernet Controller. The datasheet can b...) |
|||
| Line 9: | Line 9: | ||
==== Kernel configuration ==== | ==== Kernel configuration ==== | ||
| − | + | <pre class=apf> | |
| − | + | # make linux26-menuconfig | |
| + | </pre> | ||
<pre class="config"> | <pre class="config"> | ||
| Line 23: | Line 24: | ||
==== Additional tools ==== | ==== Additional tools ==== | ||
In order to read/write the configuration eeprom of the LAN9500, Ethtool has to be used. | In order to read/write the configuration eeprom of the LAN9500, Ethtool has to be used. | ||
| − | + | <pre class=apf> | |
| + | # make make menuconfig | ||
| + | </pre> | ||
| + | |||
<pre class="config"> | <pre class="config"> | ||
Package Selection for the target ---> | Package Selection for the target ---> | ||
Revision as of 16:57, 29 December 2009
How-to use USB to Ethernet adapters
Contents
Prerequesities
Tested hardware
SMSC LAN9500
The SMSC LAN9500 is a Hi-Speed USB 2.0 to 10/100 Ethernet Controller. The datasheet can be found here: http://www.smsc.com/media/Downloads_Public/Data_Sheets/9500.pdf. An external EEPROM is used to store the LAN9500 configuration.
Kernel configuration
# make linux26-menuconfig
Device Drivers --->
[*] Network device support --->
USB Network Adapters --->
<M> Multi-purpose USB Networking Framework
<M> CDC Ethernet support
<M> SMSC LAN95XX based USB 2.0 10/100 ethernet devices
Additional tools
In order to read/write the configuration eeprom of the LAN9500, Ethtool has to be used.
# make make menuconfig
Package Selection for the target --->
[*] Networking --->
[*] ethtool
Usage
First mount the module:
# modprobe smsc95xx
then start the new ethernet port
# ifconfig usb0 192.168.10.208 up
If the message "No EEPROM present" is displayed, this indicates that no configuration file has been detected in the EEPROM. The LAN9500 will start in a default mode and the MAC address will be randomly generated by Linux. The EEPROM can be read/write by using ethtool once the module loaded
ethtool -e usb0 (eeprom read) ethtool -E usb0 (eeprom write)
Further informcations concerning the EEPROM containt can be found on the SMSC web site.
