Difference between revisions of "Wireless extension board"
From ArmadeusWiki
(→Resources) |
m (→Linux configuration) |
||
| Line 9: | Line 9: | ||
* Linux will have to be configured in order to tell it that an APW is connected to your APF27Dev: | * Linux will have to be configured in order to tell it that an APW is connected to your APF27Dev: | ||
<pre class="host"> | <pre class="host"> | ||
| − | $ make | + | $ make linux-menuconfig |
</pre> | </pre> | ||
<pre class="config"> | <pre class="config"> | ||
| Line 24: | Line 24: | ||
<pre class="host"> | <pre class="host"> | ||
| − | $ make | + | $ make linux |
</pre> | </pre> | ||
* reflash you Linux kernel | * reflash you Linux kernel | ||
Latest revision as of 18:07, 4 September 2013
This extension board (APW) from Armadeus Systems, designed to be pluggable on an APF27Dev, will give your system the following wireless capabilities (depending on the options you selected):
Figure 1: APW with all options populated (no antenna)
Linux configuration
- Linux will have to be configured in order to tell it that an APW is connected to your APF27Dev:
$ make linux-menuconfig
System Type --->
Freescale MXC Implementations --->
...
Extension board (Wireless (APW)) --->
[ ] GSM/GPRS Modem (NEW)
[ ] Bluetooth & WiFi module (NEW)
[ ] CSI (Camera) pass-through (NEW)
[ ] GPS module (NEW)
Select the options installed on your APW board (WiFi can only be selected if SPI3 port is not selected for general purpose (SDHC1 & SPI3 are muxed)).
$ make linux
- reflash you Linux kernel
Features
- WiFi: use Linux libertas driver
- Bluetooth
- GPS
- GSM/GPRS
