Difference between revisions of "Pci debug"
From ArmadeusWiki
m (→Buildroot configuration) |
(→Links) |
||
Line 81: | Line 81: | ||
= Links = | = Links = | ||
− | This tool come from an altera [http://www.alteraforum.com/forum/showthread.php?t=35678 forum post], and the archive code can be found [ | + | This tool come from an altera [http://www.alteraforum.com/forum/showthread.php?t=35678 forum post], and the archive code can be found [https://github.com/Martoni/pcie_debug here]. |
Latest revision as of 15:23, 21 April 2021
Introduction
pci_debug is a useful tool meant to access PCIe BARx memory from userspace.
Buildroot configuration
- Should be done by default on APF6_SP
- Select pci_debug:
Target packages ---> Hardware handling ---> [*] pcidebug
- then rebuild your BSP:
$ make
Using pci_debug
- First find your PCI device name with lspci :
# lspci 00:00.0 PCI bridge: Device 16c3:abcd (rev 01) 01:00.0 Unclassified device [0013]: Altera Corporation Device e001 (rev 01)
For example here, we want to access Altera PCI device, then name is : 01:00.0
- Launch pci_debug with the BAR number in option (-b) :
# pci_debug -s 01:00.0 -b0 # ./pci_debug -s 01:00.0 -b0 PCI debug --------- - accessing BAR0 - region size is 4194304-bytes - offset into region is 0-bytes ? Help d[width] addr len Display memory starting from addr [width] 8 - 8-bit access 16 - 16-bit access 32 - 32-bit access (default) c[width] addr val Change memory at addr to val e Print the endian access mode e[mode] Change the endian access mode [mode] b - big-endian (default) l - little-endian f[width] addr val len inc Fill memory addr - start address val - start value len - length (in bytes) inc - increment (defaults to 1) q Quit Notes: 1. addr, len, and val are interpreted as hex values addresses are always byte based PCI>
- You can then access BAR0 memory on PCI> prompt.
- Reading 0x20 values from address 0 :
PCI> d32 0 20 00000000: 12345678 12345678 12345678 12345678 00000010: 12345678 12345678 12345678 12345678 PCI>
Links
This tool come from an altera forum post, and the archive code can be found here.