Difference between revisions of "Tianma TM035"
From ArmadeusWiki
m (→Description) |
|||
Line 4: | Line 4: | ||
Module flat cable can be used to directly connect the TM035 to the [[APF28Dev]]. LCD resolution: 320x240. | Module flat cable can be used to directly connect the TM035 to the [[APF28Dev]]. LCD resolution: 320x240. | ||
+ | |||
+ | ==How to enable Tianma TM035 support on 2.6.35 APF28 kernel== | ||
+ | * Remove the following patch and rebuild your Linux image: | ||
+ | <pre class="host> | ||
+ | $ rm patches/linux/2.6.35/459-armadeus-mx28_fix_16bits_video.patch | ||
+ | $ make linux-rebuild | ||
+ | </pre> | ||
+ | * Reflash the image and activate TM035 by default in U-Boot: | ||
+ | <pre class="apf"> | ||
+ | BIOS> run update_kernel | ||
+ | BIOS> setenv extrabootargs lcd_panel=tm035 | ||
+ | BIOS> saveenv | ||
+ | </pre> | ||
==How to enable Tianma TM035 support on recent kernel (3.19+)== | ==How to enable Tianma TM035 support on recent kernel (3.19+)== |
Latest revision as of 10:42, 18 August 2015
Contents
Description
This Tianma's LCD module allow you to add a display and a touchscreen to your APF28Dev.
Module flat cable can be used to directly connect the TM035 to the APF28Dev. LCD resolution: 320x240.
How to enable Tianma TM035 support on 2.6.35 APF28 kernel
- Remove the following patch and rebuild your Linux image:
$ rm patches/linux/2.6.35/459-armadeus-mx28_fix_16bits_video.patch $ make linux-rebuild
- Reflash the image and activate TM035 by default in U-Boot:
BIOS> run update_kernel BIOS> setenv extrabootargs lcd_panel=tm035 BIOS> saveenv
How to enable Tianma TM035 support on recent kernel (3.19+)
You have to edit the APF28Dev's device tree file. The file is buildroot/output/build/linux-XXX/arch/arm/boot/dts/imx28-apf28dev.dts .
- Find the following lines and modify them as the comment says:
... lcdif@80030000 { pinctrl-names = "default"; pinctrl-0 = <&lcdif_16bit_pins_a &lcdif_pins_apf28dev>; //display = <&st0700>; /* * To use the Tianma TM035 LCD comment the line above * and uncomment the line below. */ display = <&tm035>; status = "okay"; ...
- Rebuild the device tree
$ make linux-rebuild
- Copy the new dtb file (located in buildroot/output/images) in your tftpboot directory and update it on your board. In U-Boot:
BIOS> run update_dtb