Difference between revisions of "LQ043 Adapt"

From ArmadeusWiki
Jump to: navigation, search
m
Line 1: Line 1:
 
The description, the datasheet and the schematics can be found here [http://www.armadeus.com/english/products-peripherals-lq043_adapt.html]
 
The description, the datasheet and the schematics can be found here [http://www.armadeus.com/english/products-peripherals-lq043_adapt.html]
 +
 +
= Connection to the APF9328 Devlight V1 =
 +
On the Devlight V1, the LCD port is not prerouted. This means that you have to solder several wire between the vias corresponding to the LCD signals and a free place on the board where you can add a 2x15pins header.
 +
 +
Take a look at the Devlight datasheet. You will find a table representing the bottom side of the board.
 +
On the board (bottom), you will see a silkscreen indicating the names of each vias.
 +
 +
In the LQ043_Adapt datasheet, you will find the pin description of the 2x15 pins connector.
 +
 +
Connect (1 to 1) the signals of the LQ043_adapt to the ones of the Devlight.
 +
 
 +
* [http://www.armadeus.com/_downloads/apf9328DevLight/documentation/ DevlightV1 datasheet]
 +
 +
= Connection to the APF9328 Devlight V2 =
 +
A simple flat cable (PC like) can be used to connect the LQ043_Adapt to the devlight V2.
 +
 +
Align the pins 1 (square via) on both boards together.
 +
 +
* [http://www.armadeus.com/_downloads/apf9328DevLight/documentation/ DevlightV2 datasheet]
 +
  
  
 
[[Category:ExtensionBoards]]
 
[[Category:ExtensionBoards]]

Revision as of 20:56, 11 April 2008

The description, the datasheet and the schematics can be found here [1]

Connection to the APF9328 Devlight V1

On the Devlight V1, the LCD port is not prerouted. This means that you have to solder several wire between the vias corresponding to the LCD signals and a free place on the board where you can add a 2x15pins header.

Take a look at the Devlight datasheet. You will find a table representing the bottom side of the board. On the board (bottom), you will see a silkscreen indicating the names of each vias.

In the LQ043_Adapt datasheet, you will find the pin description of the 2x15 pins connector.

Connect (1 to 1) the signals of the LQ043_adapt to the ones of the Devlight.

Connection to the APF9328 Devlight V2

A simple flat cable (PC like) can be used to connect the LQ043_Adapt to the devlight V2.

Align the pins 1 (square via) on both boards together.