AS1531

From ArmadeusWiki
Revision as of 14:24, 26 April 2011 by Salocin68 (Talk | contribs)

Jump to: navigation, search

Introduction

AS1531 is a 8 channels 12bits analog do digital converter made by Austriamicrosystem. The driver is included in ARMadeus distribution and can be used with the APF51Dev board.

Soldering

AS1531 chip use a SPI bus to communicate with the microprocessor, then to use it on APFx board it must be connected to a SPI bus.

On the APF51Dev, the AS1531 is connected to the SPI1 bus by default.

On the APF27-Dev board it can be soldered on SPI3 bus, which is availbale on connector J8.

Soldering schema for SPI3 APF27-dev
J8 pin AS1531 pin
SD1_D0_SPI3_MISO DOUT
SD1_D3_SPI3_SS CSN
SD1_CMD_SPI3_MOSI DIN
SP1_CLK_SPI3_SCLK SCLK

Driver

The driver is included in ARMadeus distribution, then to use it, select it :

[  ] $ make linux26-menuconfig
Device Drivers  --->
    <M> Hardware Monitoring support  --->
        <M>   Austria Microsystems AS1531 Analog to Digital Converter

Then compile the distribution :

[  ] $ make linux26;make

Use it

modprobe

To use the ADC first load module hwmon and as1531:

# modprobe hwmon
# modprobe as1531

read values

# cd /sys/bus/spi/devices/spi0.0/
# ls
driver     in1_input  in4_input  in7_input  modalias   subsystem
hwmon      in2_input  in5_input  in_max     name       uevent
in0_input  in3_input  in6_input  in_min     power

or:

# cd /sys/class/hwmon/hwmon0/device/
# ls
driver     in1_input  in4_input  in7_input  modalias   subsystem
hwmon      in2_input  in5_input  in_max     name       uevent
in0_input  in3_input  in6_input  in_min     power

To read adc value just «cat» an input :

# cat in5_input 
887

All values read are in milivolts.