Linux Debug
- Tips to do debug under linux **
Contents
Introduction
On this page, you will find usefull informations for debugging Armadeus under Linux
Testing your custom Linux kernel before flashing it
You can test a linux kernel you've generated without having to reflash your board and destroy your currently working image. Indeed Linux kernel images can be loaded and started from SDRAM with U-Boot:
BIOS> tftp 8000000 linux-kernel-2.6.16-arm.bin BIOS> bootm 8000000
Changing processor registers from Linux user space with imxregs
This tool allows you to access i.MXl registers from linux userspace/console. This way you debug your driver or access i.MXl hardware functionnalities directly from Linux console.
First, you have enable this tool in Buildroot (package selection for target):
$ make menuconfig
Once done, compile it:
$ make
The generated file is located in buildroot/build_arm_nofpu/imxregs-1.0/. Now you can copy it on your target.
To use it, you must clear PAR 1&2 registers (register access rights) before launching Linux kernel, so in U-Boot type:
BIOS> mw.l 0x00200008 0 BIOS> mw.l 0x00210008 0
If you use it frequently, you can define a small script in U-Boot:
BIOS> setenv unlock_regs mw.l 0x00200008 0\; mw.l 0x00210008 0 BIOS> saveenv
and call it like that before launching your kernel:
BIOS> run unlock_regs
Then in linux, launch imxregs like that:
# imxregs REGISTER_NAME (give it the register name as printed in iMX Ref Manual or just the begining of the name)
or
# imxregs (to dump all supported registers)
Examples:
Show OCR1 registers of each GPIO Port:
# imxregs OCR1
Write 123 to OCR1_D register:
# imxregs OCR1_D 123
Changing FPGA IP's registers from Linux user space with fpgaregs
This tool allows you to access FPGA registers from linux userspace/console. This way you can easily debug your driver directly from the Linux console.
First, you have enable this tool in Buildroot (package selection for target):
$ make menuconfig
Once done, compile it:
$ make
The generated file is located in buildroot/build_arm_nofpu/fpgaregs-1.0/. Now you can copy it on your target. Then in linux, launch it like that:
# fpgaregs address (for read) or fpga address value (for write)
Examples:
Show register at internal FPGA address 0x0010:
# fpgaregs 0x0010
Write 0x0123 to FPGA register 0x0020:
# fpgaregs 0x0020 0x0123