Difference between revisions of "APF/OPOS as Wi-Fi Access Point"
From ArmadeusWiki
(New page: {{Under Construction}} ==Installation== * You will need hostapd: <pre class="host"> $ make menuconfig </pre> <pre class="config"> Target packages ---> Networking applications ---> ...) |
(→Installation) |
||
| Line 2: | Line 2: | ||
==Installation== | ==Installation== | ||
| − | * You will need hostapd: | + | * You will need hostapd (installed by default on [[APF6]]): |
<pre class="host"> | <pre class="host"> | ||
$ make menuconfig | $ make menuconfig | ||
| Line 14: | Line 14: | ||
[ ] Enable WPS | [ ] Enable WPS | ||
</pre> | </pre> | ||
| + | |||
| + | ==Configuration== | ||
| + | * Create ''/etc/hostapd/'' directory and put it ''hostapd.conf'' configuration file: | ||
| + | <pre class="apf"> | ||
| + | $ mkdir -p /etc/hostapd/ | ||
| + | $ vi /etc/hostapd/hostapd.conf | ||
| + | |||
| + | interface=wlan0 | ||
| + | ssid=APF6 | ||
| + | hw_mode=g | ||
| + | channel=6 | ||
| + | #auth_algs=1 | ||
| + | wpa=2 | ||
| + | wpa_passphrase=YOUHOULESBILOUS | ||
| + | wpa_key_mgmt=WPA-PSK WPA-PSK-SHA256 | ||
| + | </pre> | ||
| + | * here we used fixed channel (6) (as some drivers can't allow hostapd to find less occupied channel through scanning) | ||
| + | * security is WPA2-PSK. To have "Open" Access Point uncomment ''#auth_algs=1'' and comment 3 wpa lines | ||
Revision as of 22:14, 16 September 2015
Page under construction...
Informations on this page are not guaranteed !!
Installation
- You will need hostapd (installed by default on APF6):
$ make menuconfig
Target packages --->
Networking applications --->
[*] hostapd
[ ] Enable EAP
[ ] Enable WPS
Configuration
- Create /etc/hostapd/ directory and put it hostapd.conf configuration file:
$ mkdir -p /etc/hostapd/ $ vi /etc/hostapd/hostapd.conf interface=wlan0 ssid=APF6 hw_mode=g channel=6 #auth_algs=1 wpa=2 wpa_passphrase=YOUHOULESBILOUS wpa_key_mgmt=WPA-PSK WPA-PSK-SHA256
- here we used fixed channel (6) (as some drivers can't allow hostapd to find less occupied channel through scanning)
- security is WPA2-PSK. To have "Open" Access Point uncomment #auth_algs=1 and comment 3 wpa lines
