Difference between revisions of "BootStrap"
|Line 1:||Line 1:|
Instructions to use the Armadeus U-Boot
Instructions to use the Armadeus U-Boot utility.
Revision as of 15:42, 9 November 2009
Instructions to use the Armadeus U-Boot recovery utility. If you thought you bricked your board by flashing a bad bootloader, don't worry: there is a solution to recover it, without a JTAG probe.
The uboot_recover tool is a Python piece of code that allows you to automatically install a new U-Boot from scratch or to recover it in case of failure. uboot_recover requires the python and pyserial packages to be installed on your PC:
$ sudo apt-get install python-serial
This utility communicates with the i.MXL/i.MX27 processor while in bootstrap mode (See i.MXL/i.MX27 reference manual for more informations).
To enter the bootstrap mode, you have to put the bootstrap jumper and reset your Armadeus board:
- Go inside the software/uboot_recover/ directory and launch:
$ python apf9328_recover.py
$ python apf27_recover.py
- The tool will ask you to specify the serial port on which the board is connected. Under Linux please use /dev/ttySx or /dev/ttyUSBx and under Window$ use COMx.
- Then the size of the SDRAM has to be indicated. Default value is 16Mo for the APF9328 and 64Mo for the APF27.
- The tool will then try to synchronize with the i.MX (on APF9328 only). When you see that message reset your board:
Re-synchronizing... Please reset your board in bootstrap mode ! Please reset your board in bootstrap mode ! Please reset your board in bootstrap mode ! Please reset your board in bootstrap mode !
- Then you can specify whether the environment variables (IP, your special scripts...) have to be erased or not. If your board does not start anymore after a first uboot_recover, please responds by 'y'
- The following messages are then displayed (on APF9328):
loading file ramprogrammer.bin. Please wait... 284 octets Loading file u-boot.bin. Please wait... 150304 octets loading file flashprogrammer.bin. Please wait... 668 octets Flashing please wait... . uBoot successfully recovered !
- The following messages are then displayed (on APF27):
run flash_uboot device 0 offset 0x0, size 0xa0000 nand_unlock: start: 00000000, length: 655360! NAND flash successfully unlocked NAND erase: device 0 offset 0x0, size 0xa0000 OK NAND write: device 0 offset 0x0, size 0xa0000 655360 bytes written: OK NAND flash successfully locked device 0 offset 0xa0000, size 0x7f60000 nand_unlock: start: 000a0000, length: 133562368! NAND flash successfully unlocked Flashing of uboot succeed BIOS>uBoot successfully recovered !