Difference between revisions of "Communicate"

From ArmadeusWiki
Jump to: navigation, search
m (Connection Setup)
m (move specific part somewhere else)
Line 11: Line 11:
 
* '''Linux''': [[Connection with U-Boot on Linux|configuring RS-232 and TFTP on a Linux Host to communicate with your board]]
 
* '''Linux''': [[Connection with U-Boot on Linux|configuring RS-232 and TFTP on a Linux Host to communicate with your board]]
 
* '''Window$''': [[Windows uBoot Connection | configuring RS-232 and TFTP on a Window$ Host to communicate with your board]]
 
* '''Window$''': [[Windows uBoot Connection | configuring RS-232 and TFTP on a Window$ Host to communicate with your board]]
 
==U-Boot communication quick check==
 
* Verify that your RS232 cable is correctly connected
 
* The [[BootStrap#Introduction|bootstrap jumper]] must be removed
 
* Start the RS232 terminal on the Host side (115200 bauds 8N1)
 
* Reset the board
 
* U-Boot must start
 
 
[[Linux_start_screenshot | Here is a screenshot]] of what you will see on your Terminal emulator during the Linux boot.
 

Revision as of 17:13, 2 March 2009

How-To connect your Armadeus board to your development Host.

Forewords

The default connection uses a simple RS232 Null-Modem cable (with or without USB<->serial adapter).
If you want to transfer data in a faster way, the Ethernet link is recommended.
At this stage, you should have something looking like that (IP addresses may change):

BoardConnection.png

Connection Setup

A Terminal emulator (for RS232 link) and a TFTP server (for Ethernet link) have to be configured, depending on your Host operating system: