Difference between revisions of "Communicate"
From ArmadeusWiki
m (→Forewords) |
m |
||
| Line 9: | Line 9: | ||
==Connection Setup== | ==Connection Setup== | ||
A Terminal emulator (for RS232 link) and a TFTP server (for Ethernet link) have to be configured, depending on your Host operating system: | A Terminal emulator (for RS232 link) and a TFTP server (for Ethernet link) have to be configured, depending on your Host operating system: | ||
| − | |||
===Linux=== | ===Linux=== | ||
| Line 17: | Line 16: | ||
[[Windows uBoot Connection | Connection with U-Boot on Window$]] | [[Windows uBoot Connection | Connection with U-Boot on Window$]] | ||
| − | ==U-Boot communication== | + | ==U-Boot communication quick check== |
* Verify that your RS232 cable is correctly connected | * Verify that your RS232 cable is correctly connected | ||
* The bootstrap jumper must be removed | * The bootstrap jumper must be removed | ||
| − | * Start the RS232 terminal on the Host side | + | * Start the RS232 terminal on the Host side (115200 bauds 8N1) |
* Reset the board | * Reset the board | ||
* U-Boot must start | * U-Boot must start | ||
[[Linux_start_screenshot | Here is a screenshot]] of what you will see on your Terminal emulator during the Linux boot. | [[Linux_start_screenshot | Here is a screenshot]] of what you will see on your Terminal emulator during the Linux boot. | ||
Revision as of 18:59, 25 February 2009
How-To connect your Armadeus board to your development Host.
Forewords
The default connection uses a simple RS232 Null-Modem cable (with or without USB<->serial adapter).
If you want to transfer data in a faster way, the Ethernet link is recommended.
At this stage, you should have something looking like that (IP addresses may change):
Connection Setup
A Terminal emulator (for RS232 link) and a TFTP server (for Ethernet link) have to be configured, depending on your Host operating system:
Linux
Connection with U-Boot on Linux
Window$
Connection with U-Boot on Window$
U-Boot communication quick check
- Verify that your RS232 cable is correctly connected
- The bootstrap jumper must be removed
- Start the RS232 terminal on the Host side (115200 bauds 8N1)
- Reset the board
- U-Boot must start
Here is a screenshot of what you will see on your Terminal emulator during the Linux boot.
