Difference between revisions of "LQ043 Adapt"
m (→Adding of a TSC2102) |
|||
| Line 21: | Line 21: | ||
* [http://www.armadeus.com/_downloads/apf9328DevLight/documentation/ DevlightV2 datasheet] | * [http://www.armadeus.com/_downloads/apf9328DevLight/documentation/ DevlightV2 datasheet] | ||
| − | ==Adding of a TSC2102== | + | ==Adding of a TSC2102 (touch panel and audio controler)== |
| − | + | For those who do not have the APF9328Devfull and would like to use a touch panel, a reserved space has been foreseen on the LQ043_adapt board to solder the [[TSC2102]] and a small regulator (LM317). This avoids developping or buying a dedicated PCB. | |
| − | In that case one more connection | + | In that case one more connection are required: |
* connect LQ043 X7 pin 2 (SSI_B5) with DevLight SSI1_TxDAT | * connect LQ043 X7 pin 2 (SSI_B5) with DevLight SSI1_TxDAT | ||
[[Category:ExtensionBoards]] | [[Category:ExtensionBoards]] | ||
[[Category:LCD]] | [[Category:LCD]] | ||
Revision as of 21:22, 23 May 2008
This adaptor board allows you to connect a Sharp's LQ043 LCD to your DevLight or DevFull.
The description, the datasheet and the schematics of can be found here [1]
Connection to the APF9328 Devlight V1
On the Devlight V1, the LCD port is not prerouted. This means that you have to solder several wire between the vias corresponding to the LCD signals and a free place on the board where you can add a 2x15pins header.
Take a look at the Devlight datasheet. You will find a table representing the bottom side of the board. On the board (bottom), you will see a silkscreen indicating the names of each vias.
In the LQ043_Adapt datasheet, you will find the pin description of the 2x15 pins connector.
Connect (1 to 1) the signals of the LQ043_adapt to the ones of the Devlight.
Connection to the APF9328 Devlight V2
A simple flat cable (PC like) can be used to connect the LQ043_Adapt to the DevLight V2.
Align the pins 1 (square via) on both boards together.
Adding of a TSC2102 (touch panel and audio controler)
For those who do not have the APF9328Devfull and would like to use a touch panel, a reserved space has been foreseen on the LQ043_adapt board to solder the TSC2102 and a small regulator (LM317). This avoids developping or buying a dedicated PCB. In that case one more connection are required:
- connect LQ043 X7 pin 2 (SSI_B5) with DevLight SSI1_TxDAT
