Difference between revisions of "Tianma TM035"
From ArmadeusWiki
SebastienSz (Talk | contribs) m |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
==Description== | ==Description== | ||
| − | This Tianma's LCD module | + | This Tianma's LCD module allow you to add a display and a touchscreen to your [[APF28Dev]]. |
| − | Module flat cable can be used to connect the TM035 to the [[APF28Dev]]. LCD resolution: 320x240. | + | Module flat cable can be used to directly connect the TM035 to the [[APF28Dev]]. LCD resolution: 320x240. |
| + | |||
| + | ==How to enable Tianma TM035 support on 2.6.35 APF28 kernel== | ||
| + | * Remove the following patch and rebuild your Linux image: | ||
| + | <pre class="host> | ||
| + | $ rm patches/linux/2.6.35/459-armadeus-mx28_fix_16bits_video.patch | ||
| + | $ make linux-rebuild | ||
| + | </pre> | ||
| + | * Reflash the image and activate TM035 by default in U-Boot: | ||
| + | <pre class="apf"> | ||
| + | BIOS> run update_kernel | ||
| + | BIOS> setenv extrabootargs lcd_panel=tm035 | ||
| + | BIOS> saveenv | ||
| + | </pre> | ||
==How to enable Tianma TM035 support on recent kernel (3.19+)== | ==How to enable Tianma TM035 support on recent kernel (3.19+)== | ||
Latest revision as of 10:42, 18 August 2015
Contents
Description
This Tianma's LCD module allow you to add a display and a touchscreen to your APF28Dev.
Module flat cable can be used to directly connect the TM035 to the APF28Dev. LCD resolution: 320x240.
How to enable Tianma TM035 support on 2.6.35 APF28 kernel
- Remove the following patch and rebuild your Linux image:
$ rm patches/linux/2.6.35/459-armadeus-mx28_fix_16bits_video.patch $ make linux-rebuild
- Reflash the image and activate TM035 by default in U-Boot:
BIOS> run update_kernel BIOS> setenv extrabootargs lcd_panel=tm035 BIOS> saveenv
How to enable Tianma TM035 support on recent kernel (3.19+)
You have to edit the APF28Dev's device tree file. The file is buildroot/output/build/linux-XXX/arch/arm/boot/dts/imx28-apf28dev.dts .
- Find the following lines and modify them as the comment says:
...
lcdif@80030000 {
pinctrl-names = "default";
pinctrl-0 = <&lcdif_16bit_pins_a
&lcdif_pins_apf28dev>;
//display = <&st0700>;
/*
* To use the Tianma TM035 LCD comment the line above
* and uncomment the line below.
*/
display = <&tm035>;
status = "okay";
...
- Rebuild the device tree
$ make linux-rebuild
- Copy the new dtb file (located in buildroot/output/images) in your tftpboot directory and update it on your board. In U-Boot:
BIOS> run update_dtb
