Difference between revisions of "Qsys USB BLASTER Jtag-avalon-MM"
From ArmadeusWiki
(→Instanciate Jtag-avalon-MM) |
|||
(One intermediate revision by the same user not shown) | |||
Line 2: | Line 2: | ||
[[Category: Quartus]] | [[Category: Quartus]] | ||
[[Category: USB-Blaster]] | [[Category: USB-Blaster]] | ||
+ | [[Category: APF6_SP]] | ||
+ | [[Category: CycloneV]] | ||
+ | [[Category: Qsys]] | ||
+ | |||
== Introduction == | == Introduction == | ||
Line 16: | Line 20: | ||
== Access avalon-MM registers == | == Access avalon-MM registers == | ||
− | * Launch | + | * Launch System console in Quartus : |
<pre> | <pre> | ||
tools -> System debugging tools -> system console | tools -> System debugging tools -> system console |
Latest revision as of 15:28, 23 August 2017
Introduction
It's possible to access avalon-MM bus with an USB-Blaster connected to jtag. To do that a special ip-core must be instanciated in Qsys and a system console must be launched in Quartus.
Instanciate Jtag-avalon-MM
In Qsys library, the component to instanciate is named JTAG to Avalon Master Bridge.
- Click twice on it to integrate it in your project then connect the clock and reset on the same signal than the avalon slave you want to access.
- Once done, plug the avalon interface «master» on the avalon slave interface you want to access.
- Generate the HDL files then synthesize all design.
Access avalon-MM registers
- Launch System console in Quartus :
tools -> System debugging tools -> system console
- Connect to USB-BLaster JTAG-avalon-MM instance :
% set masters [get_service_paths master]
/devices/5CGXBC3B(6|7)|5CGXFC3B(6|7)@1#1-1.2.4/(link)/JTAG/jtag_phy_1.jtag/phy_1/master
% set master [lindex $masters 0]
/devices/5CGXBC3B(6|7)|5CGXFC3B(6|7)@1#1-1.2.4/(link)/JTAG/jtag_phy_1.jtag/phy_1/master
% open_service master $master
- Write 32bits value
% master_write_32 $master 0x4 0xdeadbeef
- Read 32bits value
% master_read_32 $master 0x0 2