Difference between revisions of "USB Boot"
From ArmadeusWiki
(rootwait instead of rootdelay) |
|||
(One intermediate revision by one other user not shown) | |||
Line 1: | Line 1: | ||
− | {{Note|Only possible if your docking board has an USB Host controller ;- | + | {{Note|Only possible if your docking board has an USB Host controller ;-)}} |
===Prepare your key=== | ===Prepare your key=== | ||
Line 31: | Line 31: | ||
* Linux should be compiled with USB Host driver as static ('''done by default in current Armadeus configuration'''). For example on the APF9328: | * Linux should be compiled with USB Host driver as static ('''done by default in current Armadeus configuration'''). For example on the APF9328: | ||
<pre class="host"> | <pre class="host"> | ||
− | $ make | + | $ make linux-menuconfig |
</pre> | </pre> | ||
<pre class="config"> | <pre class="config"> |
Latest revision as of 17:49, 6 August 2018
Prepare your key
- create a partition on your USB key (supposing it is recognized as /dev/sdb)
$ sudo fdisk /dev/sdb n p 1 <ENTER> <ENTER> w
- format it as ext2:
$ sudo mkfs.ext2 /dev/sdb1
- mount it:
$ sudo mount /dev/sdb1 /media/disk/
- copy rootfs on it:
$ make shell_env $ source armadeus_env.sh $ sudo tar xvf $ARMADEUS_ROOTFS_TAR -C /media/disk/ $ sudo umount /media/disk/
Prepare your kernel
- Linux should be compiled with USB Host driver as static (done by default in current Armadeus configuration). For example on the APF9328:
$ make linux-menuconfig
Device Drivers ---> Armadeus specific drivers ---> <*> isp1761 USB 2.0 Host controller
Set environment variables in U-Boot
BIOS> setenv usbroot /dev/sda1 BIOS> setenv usbrootfstype ext2 BIOS> setenv addusbargs setenv bootargs \${bootargs} root=\${usbroot} rootfstype=\${usbrootfstype} rootwait BIOS> setenv usbboot setenv bootargs \${console}\;run addusbargs addipargs\; bootm \${kernel_addr} ... BIOS> saveenv
Let's go
BIOS> run usbboot