Difference between revisions of "Beginner's tutorial step 1"

From ArmadeusWiki
Jump to: navigation, search
m
m
Line 11: Line 11:
  
  
* Connect your PC (= "the Host") to your board with a [http://en.wikipedia.org/wiki/Null_modem null-modem RS232 cable] (only Rx/Tx/Gnd signals are needed). If you don't have a RS232 port on your Host, you can use a "USB <-> RS-232" converter (you'll still require the null-modem cable).
+
* Connect your PC (= "the Host") to your board with a standard null-modem RS232 DB9 cable. If you don't have a RS232 port on your Host, you can use a "USB <-> RS-232" converter (you'll still require the null-modem cable).
  
 
[[Image:rs232cable_connected.png|center|frame|RS232 Null Modem cable connected on the development board]]
 
[[Image:rs232cable_connected.png|center|frame|RS232 Null Modem cable connected on the development board]]

Revision as of 09:25, 18 May 2009

  • Plug your APFxx module to your development board (custom or DevLight/DevFull) (your system will be hereafter referred to as "the Target")

File:Apf9328 on devfull.png File:Apf27 on dev27.png


  • Connect your PC (= "the Host") to your board with a standard null-modem RS232 DB9 cable. If you don't have a RS232 port on your Host, you can use a "USB <-> RS-232" converter (you'll still require the null-modem cable).
File:Rs232cable connected.png
RS232 Null Modem cable connected on the development board
  • Connect your Target to your local network with an Ethernet Cable. If you don't any network, you can use an Ethernet crossover cable to directly connect your Target and your Host.


Navigation:

<< Previous step    You are in step N°1    Next step >>