Difference between revisions of "Beginner's tutorial step 1"
From ArmadeusWiki
m |
m |
||
| Line 16: | Line 16: | ||
[[Image:rs232cable_connected.png|center|frame|RS232 Null Modem cable connected on the development board]] | [[Image:rs232cable_connected.png|center|frame|RS232 Null Modem cable connected on the development board]] | ||
| − | * Connect your Target to your local network with an Ethernet Cable. If you don't any network, you can use [[Wikipedia:Ethernet_crossover_cable|an Ethernet crossover cable]]. | + | * Connect your Target to your local network with an Ethernet Cable. If you don't any network, you can use [[Wikipedia:Ethernet_crossover_cable|an Ethernet crossover cable]] to directly connect your Target and your Host. |
{{TutorialBar|Beginner's_tutorial|Beginner's_tutorial_step_2|1}} | {{TutorialBar|Beginner's_tutorial|Beginner's_tutorial_step_2|1}} | ||
Revision as of 16:54, 15 May 2009
- Plug your APFxx module to your development board (custom or DevLight/DevFull) (your system will be hereafter referred to as "the Target")
 An APF9328 connected to a DevLight |
File:Apf9328 on devfull.png An APF9328 connected to a DevFull |
File:Apf27 on dev27.png An APF9328 connected to a Dev27 |
- Connect your PC (= "the Host") to your board with a null-modem RS232 cable (only Rx/Tx/Gnd signals are needed). If you don't have a RS232 port on your Host, you can use a "USB <-> RS-232" converter (you'll still require the null-modem cable).
File:Rs232cable connected.png
RS232 Null Modem cable connected on the development board
- Connect your Target to your local network with an Ethernet Cable. If you don't any network, you can use an Ethernet crossover cable to directly connect your Target and your Host.
| Navigation: | |
|---|---|
|
<< Previous step You are in step N°1 Next step >> | |
