Difference between revisions of "GSM/GPRS"

From ArmadeusWiki
Jump to: navigation, search
(Usage)
Line 1: Line 1:
 
{{Under_Construction}}
 
{{Under_Construction}}
  
This page will summarize informations to use the GSM/GPRS module of the APF27Wireless board.
+
This page will summarize informations to use the GSM/GPRS module of the [[Wireless_extension_board|APF27Wireless board]].
  
 
==Introduction==
 
==Introduction==
 
GSM/GPRS are generally driven through the RS232 bus. AT commands are used to dialog with the module.
 
GSM/GPRS are generally driven through the RS232 bus. AT commands are used to dialog with the module.
 
GSM MODEM of the APF27Wireless extension board (APW) is connected to the UART5 (/dev/ttySMX4) of the APF27 module.
 
GSM MODEM of the APF27Wireless extension board (APW) is connected to the UART5 (/dev/ttySMX4) of the APF27 module.
 +
 +
==Linux configuration==
 +
* Linux will have to be configured in order to tell it that an APW is connected to your APF27Dev:
 +
<pre class="host">
 +
# make linux26-menuconfig
 +
</pre>
 +
<pre class="config">
 +
System Type  --->
 +
    Freescale MXC Implementations  --->
 +
            ...
 +
            Extension board (Wireless (APW))  --->
 +
      [*] GSM/GPRS Modem (NEW)
 +
      [ ] Bluetooth & WiFi module (NEW)
 +
      [ ] CSI (Camera) pass-through (NEW)
 +
      [ ] GPS module (NEW)
 +
</pre>
 +
 +
<pre class="host">
 +
$ make linux26
 +
</pre>
 +
* reflash you Linux kernel
  
 
==Usage==
 
==Usage==

Revision as of 17:44, 30 December 2009

Page under construction... Construction.png Informations on this page are not guaranteed !!

This page will summarize informations to use the GSM/GPRS module of the APF27Wireless board.

Introduction

GSM/GPRS are generally driven through the RS232 bus. AT commands are used to dialog with the module. GSM MODEM of the APF27Wireless extension board (APW) is connected to the UART5 (/dev/ttySMX4) of the APF27 module.

Linux configuration

  • Linux will have to be configured in order to tell it that an APW is connected to your APF27Dev:
# make linux26-menuconfig
System Type  --->
    Freescale MXC Implementations  --->
            ...
            Extension board (Wireless (APW))  --->
       [*] GSM/GPRS Modem (NEW)
       [ ] Bluetooth & WiFi module (NEW)
       [ ] CSI (Camera) pass-through (NEW)
       [ ] GPS module (NEW)
$ make linux26
  • reflash you Linux kernel

Usage

Configure serial port

# stty -F /dev/ttySMX4 raw -echo -echoe -echok

AT commands

# cu -l /dev/ttySMX4

Tools to look at

Links