Search results

Create the page "Configure or flash FPGA ?" on this wiki! See also the search results found.

• Target Software Installation
  On this page you will learn how to update (from U-Boot) the Flash's partitions of your APF module storing the Linux, rootfs and U-Boot softwa ==Configure U-Boot==
  19 KB (2,783 words) - 09:46, 9 September 2021
• Power management
  | FPGA || xxxmA || don't configure it | i.MXL (proc + SDRAM + Flash) || ||
  5 KB (693 words) - 09:35, 1 July 2016
• Armadeus 3
  *New Flash partition mapping on the target : Armadeus 3 first command to use according to your <board> (apf9328 or apf27): make <board>_defconfig
  20 KB (2,829 words) - 14:12, 30 June 2022
• JTAG
  ...-found-the-problem/ this example here], during Linux kernel portage or for FPGA debugging with ChipScope. | J9 pin 2 OR J19 pin 39 with a 68 ohm resistor inline
  26 KB (3,781 words) - 18:23, 3 June 2016
• APF6 SP The full howto
  [[Category: FPGA]] Avalon-MM Cyclone V Hard IP for PCI Express Intel FPGA IP <- 19.1
  17 KB (2,359 words) - 15:56, 12 November 2019