Difference between revisions of "Beginner's tutorial"

Revision as of 15:55, 15 May 2009

This tutorial will guide you through the basics steps to quickly test your board / play with it and to install the development environment.

Press Next button to go to the 1rst step. Beginner's tutorial step 1

USB stands for Universal Serial Bus and is a defacto standard in the nowadays computer world. All that is related to USB protocol on your APF board.

There are 3 ways to use USB:

USB Device mode: your board can be connected to any PC's USB port and used as a standard USB device.
- See how to configure USB device mode of your APF (no specific hardware is needed except a USB cable).
USB Host mode: you can connect any standard USB devices to your board.
- See how to configure USB Host mode of the APF9328+DevFull
- See how to use USB Host on all APF boards
USB OnTheGo: your board can act as Host or Device, depending on the context. Not supported yet (only possible on the APF28 & APF51).
- See how to use USB OTG on the APF28

Navigation:
[[ \| << Previous step]] You are in step N°{{{3}}} Next step >>