Search results

Create the page "Power" on this wiki! See also the search results found.

Page title matches

Page text matches

• OOCP
  * Power the kit (AC/DC bloc) ==Power the kit==
  1 KB (247 words) - 14:07, 12 June 2009
• A simple design with Wishbone bus
  ...n 1 on J20 header (near Ethernet one)). For '''apf51Dev''' don't forget to power banks with jumper FPGA_Bank3 and FPGA_Bank1}} ...PF51Dev]] a button is already soldered to a FPGA pin. Just don't forget to power corresponding FPGA bank.<br> For [[APF9328DevFull]] a button must be connec
  10 KB (1,574 words) - 12:43, 30 June 2022
• APF9328DevFull
  * a 2.5amps DC/DC power supply with wide input supply range
  1 KB (175 words) - 09:41, 12 February 2015
• APF27
  ...dia.org/wiki/Single-board_computer Single Board Computer] targeted for low power applications, advanced GUI and extended connectivity. * Low power sleep mode (<10mW)
  9 KB (1,132 words) - 09:39, 12 February 2015
• AS1531
  in0_input in3_input in6_input in_min power in0_input in3_input in6_input in_min power
  3 KB (397 words) - 20:13, 12 February 2013
• Development boards power supply
  ...'''+ is in the middle of the connector, - on the side'''. Use a regulated power supply capable of providing at least 500mA at minimum required voltage.}}
  1 KB (242 words) - 09:13, 1 July 2015
• Embedded Linux system basis
  ...ery similar (when speaking about software) to a Desktop one, thanks to the power of the latest embedded microprocessor cores, like the ARM9™/Cortex™ one
  2 KB (247 words) - 09:31, 22 November 2016
• Specifications for a robotic card
  == Battery power, 4 mains technologies == * Li-ion battery : High density power but high price and complexe electronic control system
  1 KB (146 words) - 13:43, 27 February 2009
• Home monitoring energy
  == Power calculation == * http://www.edcheung.com/automa/power.htm
  1 KB (196 words) - 13:20, 22 January 2009
• MotionSystem
  * Power up the Armadeus board.
  32 KB (4,480 words) - 16:01, 4 April 2015
• C38A
  ...lt on C38A kit, all power supplies are connected to 5V. To provide 3.3V on power IO (DOVDD):
  3 KB (477 words) - 18:38, 8 April 2010
• Armadeus 3
  Do not forget to save your changes in FLASH, to have them available at next power up:
  20 KB (2,829 words) - 14:12, 30 June 2022
• WiFi
  Tx-Power=0 dBm Power Management:off
  7 KB (911 words) - 15:24, 30 January 2024
• Audio analog connection
  ...voltage presents normally a quiescent DC voltage of approximately half the power supply. ** the power supply (AC adaptor) itself
  3 KB (483 words) - 19:07, 31 July 2011
• APF27Dev
  ** Consequence: the AD9889 can no more be placed in low power mode by hardware.
  2 KB (246 words) - 14:53, 19 March 2021
• Simple blinking LED
  {{Note| Don't forget to power the FPGA IO bank as explained in [[datasheet]]}}
  4 KB (678 words) - 15:24, 25 November 2021
• JTAG
  ...h FPGA, the FPGA chip MUST be powered before using JTAG. Indeed, at system power-up, FPGA is low powered by cutting down the VCCAUX and VCCINT supplies unt Power the board.
  26 KB (3,781 words) - 18:23, 3 June 2016
• OV9653
  * Sensor core power supply (1,8V) is derived from 2,8V of J9.
  4 KB (607 words) - 15:59, 21 January 2014
• APF Enclosure
  ...artment below the base (and probably a battery controller to switch to low-power or shut down the system on low voltage)
  1 KB (211 words) - 23:34, 3 June 2009
• Wiki/Project changes
  ** [[APF28_PMIC|detail the capabilities of APF28's PMIC (Power Management IC)]] ..._battery_pack_for_your_APF|A new page]] has been created to explain how to power on your APF with rechargeable batteries
  34 KB (4,583 words) - 15:35, 17 March 2015

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)